Nqd jet build

I'm hoping I got my thundercat ready for a true water test gonna go sat may be nqd will be ready then

Bring your video camera so we can see too!

Been real busy lately but found the time to get back on this steering and throttle are done seal up electronics and mount ez start harness and antenna and it's ready for break in and a test run check out the pix sealed it up no leaks and I feel it looks as it should in the water didn't have fuel in it but battery and rx is there

It floats and it stays dry inside! Looking good!

Yep so far no leaks I Evan tried to start it but the motor on the ez start went up in smoke rats now got to pull the engine to get ez start off but it did run for like two seconds no vibrations either got a lot going on right now but might get a full wet test this weekend

so far

Do you have to remove the whole motor to change the starter?

Yep and might have to remove jet pump too it is a tight fit