Yeah, but I won! Made that motor finally listen to me and do what I was telling it to do, "be smooth" A guy I know used eBay for the first time a...
FLIR is made right here in Oregon, Portland. The TAU core can be purchased for a few thousand dollars and has RCA output....
Oh, yeah, then look at 2:40 in the video, IT DROPS OUT! $50K and it does not work any better than my $49.00 VTx while using a BAD antenna, when I...
I don't rant very often, if ever, but I have been following the Draganfly commercial FPV tricopter for some time now. I hate that thing. Here is a...
Tiger, solved the motor mystery. Took motor off, put in lathe, dial indicator on bell and aluminum threads. .004" TIR on bell, .023" TIR on...
Ok, now that I see it in action I would say this is "translating tendency" which makes total sense to me. The effect would be more energy needed...
They are going to build quadcopters that will fly out to you, hover overhead, and wirelessly recharge your Iphone battery when you forgot to plug...
Ah, I see that now, looks like for about $7 they will assemble this board for you. I might try one. The multuwiicopter from Australia also looks...
Each prop sort of works like the helicopter tail rotor. There is a gyro in-between the Rx and ESC. So once you have established a level hover and...
Since crashing sucks and auto leveling is cool, I found three different ways to get AL on a KK board. Two ways are DIY with the first being a huge...
I measured the AMP draw at about 9.5 amps with the throttle stick in the hovering position. I measure 160 milliamps when it is just sitting there....
Fixed and flying again, I think what I thought was good gains and poor trims was poor gains. Worked on the gains and now have a small about of...
Well it was bound to happen >:( Somehow got inverted and did not know it, as it was falling I thought why is it falling? More throttle! That just...
I was just shopping for snapware this morning, the 16 oz rectangle jobs are hard to get. Fred Meyer has a few in stock.
Oh, the orientation, I was flying this at the school so late that you had to be high enough above the horizon that it would contrast against the...
I did step 2 (In green) on this page: http://rcexplorer.se/Educational/kkguide/kkguide/tri.html But when I was just looking for that I scrolled...
Had some time this afternoon and got the Tricopter running. I was worried about the configuration, but it was about 10 times easier than I thought...
That's pretty cool, have not seen a unit like that before......
The ultimate goal would be for a Zenoah gasoline engine driven quad copter ;D All engine power would go lift, none wasted on tail rotor. The four...
So this discussion leads me to believe what I am scheming up just might work. The other issue is whether a 333Hz servo can take a 300Hz signal and...
Separate names with a comma.
