DJI Innovations: DJI released Naza-M Firmware 3.14 and Assistant Software 2.14

GPS · Jul 5, 2013

DJI Naza-M Firmware 3.14 and Assistant Software 2.14 has been released.

FUNCTIONS

Manual Mode(user select Manual, Atti and Failsafe);
Atti. Mode;
GPS Atti. Mode;
Intelligent Orientation Control(IOC)：Course lock/Home lock
Enhanced Fail-Safe：Landing / go home & landing;
Quad-rotor I, X; Hex-rotor I, V; Y, IY; Octo-rotor X, I, V;
Combination Stick Command to start; Immediate Mode and Intelligent Mode to stop;
Remote gain tuning;
Two-axis gimbal supported, Multi Gimbal Servo Output Frequency Supported;
Support Normal receiver, D-Bus Port support S-bus and PPM receiver;
Voltage Monitor and Low Voltage Protection;
4 channels transmitter support;
Five-level Motor Idle Speed adjustable in Motor Mixer;
IMU Calibration function;
Support PMU extend module, could connect with iOSD, H3-2D gimbal and Naza-M Bluetooth module(coming soon);
Add Receiver Advanced Protection Function;

WHAT’S NEW?

FIRMWARE

Optimize the compatibility for Zenmuse H3-2D gimbal.
Add calibration function of X1 channel(X1 is used for pitch control of normal gimbal and Zenmuse H3-2D gimbal).
Change the default aircraft type to X4, instead of I4.

SOFTWARE

Add calibration function of X1 channel(X1 is used for pitch control of normal gimbal and Zenmuse H3-2D).

NOTICES

For safety reasons, do not use power battery during firmware upgrade.
Make sure you reconfigure all parameters after upgrading firmware.
Click to expand...

Read more and see photos via the source link.

Source:
http://www.dji-innovations.com/dji-released-naza-m-firmware-3-14-and-assistant-software-2-14/

Log in or Sign up

DJI Innovations: DJI released Naza-M Firmware 3.14 and Assistant Software 2.14

GPS Registered

Share This Page

Log in or Sign up

DJI Innovations: DJI released Naza-M Firmware 3.14 and Assistant Software 2.14

GPS Registered

Share This Page

Useful Searches